This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Problems with NMEA out to VHF radio in OP V2.
#1
No problems with OP Version 1, but can't get NEMA data out to VHF radio in OP version 2.
(If I start diagnostics in kplex  Device 3 starts broadcasting but SignalK stops working and no localhost in OPENCPN))

(Device 1) AIS<=======(RS232 to USB cable)=======>{USB}(Pi). ok!

(Device 2) B&G plotter NEMA port<=======(RS232 to USB cable)=======>{USB}(Pi). ok!

(Device 3)B&G VHF radio NMEA port<=======(RS232 to GPIO)=======>{Pins: RX TX GND}(Pi). Problem??

Any idea what I can do?
Reply


Messages In This Thread
Problems with NMEA out to VHF radio in OP V2. - by Albin - 2020-03-10, 09:24 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)