This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[SOLVED] Help - One Wire sensors stopped working.
#1
Hi all, I have a set of one wire sensors that just just left the building... There are seven of them (with reduced resistor to make them all work) and they are hooked up onto an ESP8266 running SigKsens and have been working flawlessly for a couple off weeks now. 
           
Today they were all gone. I have not touched anything, and the voltage read from the analog port on the same ESP shows up with correct value. When I look at the sensor in my browser, they are there, but as seen in the image they all give value "null", or a simple dash in signal K. 
       

Anyone experienced anything like it before? Typically - I was putting final touches on THIS part of my build today...
Reply


Messages In This Thread
[SOLVED] Help - One Wire sensors stopped working. - by Ranur - 2020-03-15, 03:04 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)