PLEASE HELP! Im pulling my hair out!

[Sailoog]

Right now heres where im at.

Ive flashed the latest version of openplotter onto a SD card.

Ive booted and setup, ive added my serial connection /dev/ttyS0 to PyPilot and created both PyPilot connections in SignalK using the PyPilot tool.

I have the default SignalK connection in OpenCPN

I cannot get a GPS lock in openCPN.

If i run sudo cat /dev/ttyS0 I get GPS data read out.

If I add the serial connection directly to OpenCPN as serial, I get full GPS and position data.

Any ideas?

Thanks

Is Signal k getting data from pypilot? use the SK data broser: http://localhost:3000/admin/#/databrowser

Are you sure you need pypilot? if you are not using an autopilot you should make the connection of your GPS directly in SK.