This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
OpenMarine › OpenPlotter › General discussion v
PLEASE HELP! Im pulling my hair out!

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
PLEASE HELP! Im pulling my hair out!
deanfourie Offline
Junior Member
**
Posts: 43
Threads: 12
Joined: Mar 2020
Reputation: 0
#15
2020-03-26, 11:53 PM (This post was last modified: 2020-03-27, 12:20 AM by deanfourie.)
I am pretty sure.

If I remove the device from serial, I am able to do a cat /Dev/ttoS0 and get a printout
Also I cannot calibrate my compass in PyPilot, not sure if it's able to see the sensor data.
Find
Reply


Messages In This Thread
RE: PLEASE HELP! Im pulling my hair out! - by deanfourie - 2020-03-26, 11:53 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)