This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
I2C and MPU 9250 address change. (To slave - 0x69)
Here it is - the end of my frustration. The SJ solder now moved from middle-right to middle-left. That, and setting AD0 to high made the MPU 9250 available on I2C address 0x69. Now it is spitting out data and show up in Pypilot. 

*me happy*

Hope this is useful for someone else as well. 

Messages In This Thread
RE: To save someone from i2C cursing - by Ranur - 2020-03-28, 06:26 PM
RE: To save someone from i2C cursing - by Ranur - 2020-03-29, 09:37 AM
RE: I thought I could save someone from i2C cursing... - by Ranur - 2020-03-30, 06:17 PM

Forum Jump:

Users browsing this thread: 1 Guest(s)