Hydraulic controller and LS drive unit

[rsairving@hotmail.com]

Hi

I think it is now working, I think it was the slightly dodgy test wiring , The clutch seemed to be cutting out when the ram started moving. I have re rigged everything now seem to be getting a full range of movement on the ram, so now I just need to fit it in the boat to try it out, unfortunately probably not till spring.

Is there a consolidated guide on the site to amending the gain and config settings?

I did manage to blow the 10 amp fuse on the controller whilst playing around with the servo.min_speed and period, not sure why

Thanks