This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
SHINHO ELECTRONIC Multi-touch 1000 nit displays
#4
Just received my 10" screen from Shinho Electronic. It is a solid case. Knobs for switching on/off etc are on the backside.

At the back recess are the connectors for HDMi VGA and DVI. USB and power connector for the Touch screen.. Touch works with any special driver. Direct from the box.

Comes complete with the cables and power supply for 240 volt. The actually power is 12 volt.

Screen is clear with good visibility in daylight. Not yet tested with sunlight on the screen.

Capacitive touch works very responsive. However no two finger command.

The front is watertight IP65, but the back is not. Connectors are of course not watertight.

With screen is a mounting set to be a set in an instrument panel and Vesa connector points at the backside.

OpenCPN runs very well on this screen. Not yet ried on the boat.

Will make some images when installed on the boat.

Bram
Reply


Messages In This Thread
RE: SHINHO ELECTRONIC Multi-touch 1000 nit displays - by verkerkbr - 2020-07-08, 03:03 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)