2020-07-24, 06:36 PM
Probably a basic question from a pi beginner.
I have installed a noobs headless config and checked the install boots and shows the desktop by connecting a monitor via HDMI.
Now I want to use RDP to actually use the install as I don't have a suitable keyboard or mouse. Connected to openplotter wifi successfully on my win10 machine but trying RDP on 10.10.10.1:5900 results in "protocol error detected at client (code 0x1104)". This appears to be a port conflict but 5900 is not used on my desktop. Tried disabling the firewall but this made no difference.
I had expected the headless config to allow RDP without further config. Am I missing something.
Also, does Pi/Openplotter shutdown after a timeout interval? My monitor loses signal after 20 minutes or so and I have to disconnect power to reboot to get it back.
I have installed a noobs headless config and checked the install boots and shows the desktop by connecting a monitor via HDMI.
Now I want to use RDP to actually use the install as I don't have a suitable keyboard or mouse. Connected to openplotter wifi successfully on my win10 machine but trying RDP on 10.10.10.1:5900 results in "protocol error detected at client (code 0x1104)". This appears to be a port conflict but 5900 is not used on my desktop. Tried disabling the firewall but this made no difference.
I had expected the headless config to allow RDP without further config. Am I missing something.
Also, does Pi/Openplotter shutdown after a timeout interval? My monitor loses signal after 20 minutes or so and I have to disconnect power to reboot to get it back.