2020-08-21, 11:36 AM
(This post was last modified: 2020-08-21, 11:37 AM by jamos.tan@gmail.com.)
I'm trying to dive into the requirements of adjusting my current arduino and h-bridge so it can drive a hydraulic autopilot, I have a few questions:
- In some examples I see that hydraulic drivers have 4 wires, my guess is the extra 2 are clutch?
- Do I need to change motor.ino?
- And, do I need more outputs from the Arduino?
- And, I know this is gonna be a weird question, but will a hydraulic configuration also be able to drive a regular tiller if the 2 extra wires will not be connected?
Thanks
- In some examples I see that hydraulic drivers have 4 wires, my guess is the extra 2 are clutch?
- Do I need to change motor.ino?
- And, do I need more outputs from the Arduino?
- And, I know this is gonna be a weird question, but will a hydraulic configuration also be able to drive a regular tiller if the 2 extra wires will not be connected?
Thanks