2020-08-28, 04:22 AM
This is probable a simple question, but I haven't found an answer.
I am using the motor controller 2.0, from the store to control an actuator.
I have connected the controller + and - to a 12v psu, but Im not sure how to connect the actuator. Ive tried multiple ways, but none seem to works, and the psu always shorts.
Help?
I am using the motor controller 2.0, from the store to control an actuator.
I have connected the controller + and - to a 12v psu, but Im not sure how to connect the actuator. Ive tried multiple ways, but none seem to works, and the psu always shorts.
Help?