This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
New pypilot hat
#3
Hello sean
Congratulations on your fabulous work and on your patience.
I'm waiting for your next evolution of the OpenCpn plugin to be able to calibrate my IMU before installing the autopilot on board.
In the meantime, I would like to connect a 433MHz RF receiver to the Raspberry. I saw that the web application already allows to configure the buttons. But to which port of the raspberry should we connect the DATA output of the RF receiver? Can we directly connect the TTL output to the port?
Reply


Messages In This Thread
New pypilot hat - by SYWindveer - 2020-09-12, 12:16 PM
RE: New pypilot hat - by seandepagnier - 2020-09-12, 07:48 PM
RE: New pypilot hat - by Jean-Marc Douroux - 2020-09-23, 10:25 PM
RE: New pypilot hat - by seandepagnier - 2020-09-23, 10:54 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)