This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Reinforced motor controller
#11
Ready to order since almost a month ago, the trouble is, I am sidetracked from many other projects and did not order them. I am attempting to build turbine controllers using my knowledge from making autopilot controllers to extract more power from the wind or hydro with little cost, and I am also finding making new designs a lot more interesting than producing old ones... so it has delayed the progress, but I still intend to have these by the end of the year.
Reply


Messages In This Thread
Reinforced motor controller - by kinefou - 2020-09-21, 09:22 AM
RE: Reinforced motor controller - by kinefou - 2020-09-23, 07:07 AM
RE: Reinforced motor controller - by kinefou - 2020-09-25, 12:59 PM
RE: Reinforced motor controller - by hans-martijn - 2020-10-05, 08:35 AM
RE: Reinforced motor controller - by hans-martijn - 2020-12-04, 03:38 PM
RE: Reinforced motor controller - by hans-martijn - 2020-10-06, 09:48 AM
RE: Reinforced motor controller - by seandepagnier - 2020-12-04, 10:11 PM
RE: Reinforced motor controller - by hans-martijn - 2020-12-06, 10:15 AM
RE: Reinforced motor controller - by hans-martijn - 2020-12-31, 11:30 PM
RE: Reinforced motor controller - by taarn - 2021-02-21, 02:01 AM
RE: Reinforced motor controller - by hans-martijn - 2021-02-21, 08:05 PM

Forum Jump:


Users browsing this thread: 2 Guest(s)