(2020-10-02, 05:53 PM)Sailoog Wrote: Didier look at your longitude:
1601549247056;N;$GNGLL,4848.73073,N,002nn.n3016,W,104727.00,A,D*6B
1601549248054;N;$GNRMC,104728.00,A,4848.73080,N,002nn.n2963,W,0.991,,011020,,,D*78
what is that?
you should try to read data directly from your device before sending to signal k to check if your longitude is ok.
I explain in the file (2 first lines) that as I had to use an external unknown site I didn't wanted to let My position displayed:
In this file my coordinates have been replaced with : 47n.nnnxyz,N,002nn.nxyzt,W
where x, y, z, & t are the original figure
(2020-10-02, 05:53 PM)Sailoog Wrote: Didier look at your longitude:
1601549247056;N;$GNGLL,4848.73073,N,002nn.n3016,W,104727.00,A,D*6B
1601549248054;N;$GNRMC,104728.00,A,4848.73080,N,002nn.n2963,W,0.991,,011020,,,D*78
what is that?
you should try to read data directly from your device before sending to signal k to check if your longitude is ok.
I explain in the file (2 first lines) that as I had to use an external unknown site I didn't wanted to let My home position displayed :
In this file my coordinates have been replaced with : 47n.nnnxyz,N,002nn.nxyzt,W
where x, y, z, & t are the original figure.
I couldn't attach the file to a PM, nor to a post, not even include it in a code structure
Sorry for adding confusion in !
@Sailoog
FYI, as I am using an USB HDD, I had to update the firmware by these commands to allow the USB Boot:
sudo apt update
sudo apt upgrade
sudo rpi-update
sudo apt install rpi-eeprom
sudo rpi-eeprom-update -d -f /lib/firmware/raspberrypi/bootloader/stable/pieeprom-2020-07-31.bin
I dont know if it may have any impact on the freeze phenomenon ...
Cordialement
Didier B
Pi4, SSD USB3, OP 3.0 Touch SK 3.2.1 OpenCPN 5.8.4 : Thank you Thank you Thank you
Didier B
Pi4, SSD USB3, OP 3.0 Touch SK 3.2.1 OpenCPN 5.8.4 : Thank you Thank you Thank you