2020-10-02, 08:32 PM
(2020-10-02, 07:52 PM)seandepagnier Wrote: as a client you have to specify the correct ssid and key.. How did you change it to client mode?
Are you sure the remote won't switch back even if you select defaults?
You can also edit the networking file instead of rewriting the image.
Sean
Yes I used the webapp to switch to Client mode and specified the correct ssid and key
defaults is not showing up in that menu it just states no wifi detected
I also edited the networking file but I am not sure exactly how it should look.
The SSID and key were correct in the network.txt but I am not sure what the settings above should say. Currently at the top of the file it says SSID pypilot and then below that it says managed.
Then the client ssid and key and static IP address are listed.
But the biggest issue is even leaving TP as the AP and connecting OP2 to the TP wifi access point, Opencpn pypilot plugin is not connecting