2021-03-04, 09:25 AM
(2021-03-03, 10:28 PM)seandepagnier Wrote: another way to get the data to pypilot would be to "output this data as a nmea repeater or autopilot route" checkbox in opencpn connections must be checked. Then the data can be sent on port 20220 to pypilot from opencpn.
I'm not sure why pypilot is unable to directly receive the gps data from signalk though.
Hi Sean
Thanks for the reply. One problem could be the data transfer. As you can see in the picture the OUT sentences (port 20220) are all in red. Not sure why but I have tried various versions and they are all the same so I think they are not valid. This is a fresh install of Raspbian on a RPi4 with only OpenCPN installed so no Openplotter and no SignalK to mix things up. However, the Pypilot plugin still does not receive the data, any ideas will be appreciated.
Richard