2021-07-21, 11:22 AM
(2021-07-21, 09:34 AM)seandepagnier Wrote: câblez également la réinitialisation à la broche 16 et la broche ss. Donc 7 fils nécessaires d'arduino à pi.
dans pypilot/arduino/hat
make upload
Après vous pouvez exécuter pypilot_hat, mais encore une fois, il ne le détectera pas sans éditer ~/.pypilot/hat.conf et ajouter
{"arduino":{"device":"\/dev\/spidev0. 1","resetpin":16,"hardware":0.23},"lirc":"gpio4"}}
Normalement, ceci est écrit dans l'eeprom i2c afin que tout soit détecté automatiquement
Hello ok now i see in terminal whith arduino.py the command my error it i change pi and i don t active spi now i have just 3 wire SLK mosi miso and the Arduino power whith USB whith the last message i understand it Bad i make the good wiring you programm the Arduino Uno directly whith the pi thank you very much for your conseil