2020-11-03, 06:36 PM
Have you changed the input resistance to one of a higher value such as 10K?
I remember that with the original resistor the light was almost solid, barely blinking and that was because the optocoupler input was saturated.
When I added the resistor - I didn't remove the one in the circuit but just added one in the input - the flickering was more evident.
Wait to test if it works well and if it doesn't then you should increase the value of the resistor.
I remember that with the original resistor the light was almost solid, barely blinking and that was because the optocoupler input was saturated.
When I added the resistor - I didn't remove the one in the circuit but just added one in the input - the flickering was more evident.
Wait to test if it works well and if it doesn't then you should increase the value of the resistor.