2021-02-22, 02:09 PM
(This post was last modified: 2021-02-22, 04:05 PM by jamos.tan@gmail.com.)
I can confirm, I have the same issue. Seems to happen only when the sensor is connected. When disconnected, it will open.
Update:
When removing the line "gpio=6" in /boot/config.txt for the 1w interface seems to resolve the issue, that the app is not opening. So, 1w is still enabled, but just not assigned to a pin.
I have tried two separate sensors, doesn't seem to be a broken sensor or something. I can detect them from the terminal, they both have a separate unique address.
It's just like gpio=6 is causing some kind of trouble?
Update:
Tried gpio 4 , even though there is not connected anything to it. This works, but no line is added.
Tried gpio 6, with sensor connected, app will not start
Tried gpio 6, without sensor connected, app will start
Update:
When removing the line "gpio=6" in /boot/config.txt for the 1w interface seems to resolve the issue, that the app is not opening. So, 1w is still enabled, but just not assigned to a pin.
I have tried two separate sensors, doesn't seem to be a broken sensor or something. I can detect them from the terminal, they both have a separate unique address.
It's just like gpio=6 is causing some kind of trouble?
Update:
Tried gpio 4 , even though there is not connected anything to it. This works, but no line is added.
Tried gpio 6, with sensor connected, app will not start
Tried gpio 6, without sensor connected, app will start