2021-02-22, 06:22 PM
I did some test and can confirm the GPIO app does indeed launch when I disconnect the 1-wire sensors. The 1-wire sensor setup is properly setup as it was working perfectly before I did a fresh re-install of "OpenPlotter Starting"
I have not played around with GPIO pin numbers as Jamos in previous reply has. I am using this stock setup in my boot/config file
dtoverlay=w1-gpio
https://imgur.com/fHBE4K4
Thanks
I have not played around with GPIO pin numbers as Jamos in previous reply has. I am using this stock setup in my boot/config file
dtoverlay=w1-gpio
https://imgur.com/fHBE4K4
Thanks