This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
OpenMarine › OpenPlotter › General discussion v
New OpenPlotter GPIO app available

Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
New OpenPlotter GPIO app available
abarrow Offline
Moderator
*****
Posts: 579
Threads: 65
Joined: Nov 2016
Reputation: 20
#81
2021-10-19, 07:05 PM
I just installed this on a new OpenPlotter installation. 

Are there any tricks to getting pigpiod to run? When I check my status it shows pigpiod not running.
Find
Reply


Messages In This Thread
New OpenPlotter GPIO app available - by Sailoog - 2020-10-22, 10:51 AM
RE: New OpenPlotter GPIO app available - by MatsA - 2020-11-03, 07:25 PM
RE: New OpenPlotter GPIO app available - by Lazzz - 2021-01-17, 09:38 PM
RE: New OpenPlotter GPIO app available - by Lazzz - 2021-01-17, 09:57 PM
RE: New OpenPlotter GPIO app available - by Lazzz - 2021-01-17, 09:50 PM
RE: New OpenPlotter GPIO app available - by Lazzz - 2021-01-17, 10:08 PM
RE: New OpenPlotter GPIO app available - by Lazzz - 2021-01-18, 07:00 AM
RE: New OpenPlotter GPIO app available - by Lazzz - 2021-05-21, 02:17 AM
RE: New OpenPlotter GPIO app available - by Lazzz - 2021-05-21, 11:46 PM
RE: New OpenPlotter GPIO app available - by Lazzz - 2021-06-08, 10:52 PM
RE: New OpenPlotter GPIO app available - by Lazzz - 2021-06-09, 10:21 PM
RE: New OpenPlotter GPIO app available - by abarrow - 2021-10-19, 07:05 PM

Forum Jump:


Users browsing this thread: 4 Guest(s)