2020-12-07, 12:04 PM
(This post was last modified: 2020-12-07, 12:47 PM by Divemaster.)
I have question about Rapsberry Pi4 and BMP180. There is BMP280 on list of supported sensors but there are no BMP180. Do you have idea the BMP180 should work in place of BMP280 (on the same driver) or not? I have connected BMP180 to Rapsberry in BMP280 place and it is visible on address 77 like presure and temperature sensor but there any (visible ) data was sended by this sensor to Signal K. I have connected it on UDP 51000. But i dont see any data on NMEA monitor in OpenCPN.
It is only becouse im used PMB180 in place BMP280? or there are something wrong with my configuration of Signal K and OoenCPN?
It is only becouse im used PMB180 in place BMP280? or there are something wrong with my configuration of Signal K and OoenCPN?