2020-11-08, 07:35 PM
I've used e3372 for quite a while, but not with OpenPlotter, so can't help with OP stuff. Sounds like you are missing routing.
My RPi is a headless system configured with Ansible. In case it helps the relevant stuff is
https://github.com/tkurki/marinepi-provi...ml#L42-L45
https://github.com/tkurki/marinepi-provi...nat_router
192.168.8.100 is the ip address of your RPi and 192.168.8.1 is the ip of the dongle, that is acting as the gateway in the 192.168.8.x segment. You see 192.168.8.1 as the address when accessing its web ui.
My RPi is a headless system configured with Ansible. In case it helps the relevant stuff is
https://github.com/tkurki/marinepi-provi...ml#L42-L45
https://github.com/tkurki/marinepi-provi...nat_router
192.168.8.100 is the ip address of your RPi and 192.168.8.1 is the ip of the dongle, that is acting as the gateway in the 192.168.8.x segment. You see 192.168.8.1 as the address when accessing its web ui.