2021-01-02, 07:46 PM
Hi,
I am done with my Pypilot prototype. I am very close to the goal, but facing a strange issue.
When i send an order to move the actuator tilnypilot/Arduino Nano are sending the command properly until the vnh5019.
On the vnh5019 when i want to go left or right i see the red or green led lighting. I checked, the input voltage : 12 v but when i checked the outpout A and outpout B the current sens change properly, but... the Output voltage is only 2V so the actuator is not moving, of course !
The acutator is working properly when i plug it on the 12V
In the mortor.ino i just uncommented the folwing lines :
I think it dosent come from the vnh5019 because, i bought two and i have exactly the same issue with the both.
What am i doing wrong ?
I am done with my Pypilot prototype. I am very close to the goal, but facing a strange issue.
When i send an order to move the actuator tilnypilot/Arduino Nano are sending the command properly until the vnh5019.
On the vnh5019 when i want to go left or right i see the red or green led lighting. I checked, the input voltage : 12 v but when i checked the outpout A and outpout B the current sens change properly, but... the Output voltage is only 2V so the actuator is not moving, of course !
The acutator is working properly when i plug it on the 12V
In the mortor.ino i just uncommented the folwing lines :
Code:
#define VNH2SP30 // defined if this board is used
#define DISABLE_TEMP_SENSE // if no temp sensors avoid errors
#define DISABLE_VOLTAGE_SENSE // if no voltage sense
#define DISABLE_RUDDER_SENSE // if no rudder senseI think it dosent come from the vnh5019 because, i bought two and i have exactly the same issue with the both.
What am i doing wrong ?