This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Bizarre MPU9250 behaviour
#1
I’ve recently tried adding an MPU9250 for heading and attitude information. However, it shows up on the I2C address list and provides valid data for around 10-30s after connection or boot, but then stops sending data and the I2C address list becomes a mess of random addresses that aren’t connected. 

I suspect it’s a dodgy MPU, but before I send it back does anyone know what the hell is going on?
Reply


Messages In This Thread
Bizarre MPU9250 behaviour - by dreisday - 2021-01-08, 09:18 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)