This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
OpenMarine › OpenPlotter › Bug Reports v
Air pressure with Moitessier HAT

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Air pressure with Moitessier HAT
Geronius Offline
Junior Member
**
Posts: 20
Threads: 2
Joined: Sep 2018
Reputation: 2
#5
2021-02-07, 01:16 PM (This post was last modified: 2021-02-07, 01:20 PM by Geronius.)
(2021-01-15, 12:15 PM)Luckbert Wrote: ...
I have a Moitessier HAT V. 1.0 in use. 
I noticed that the air pressure is not displayed correctly
...
Hi, same situation here. Odd outside pressure values are displayed in OpenCPN/SignalK - way too high ~2100 hPa.
This situation evolved after almost 2 years of perfect performance.

I checked the hat by issuing this command:   
~/moitessier/app/sensors/MS5607-02BA03 /dev/i2c-1 1 1
Output: reading PROM failed.
Appears to be a CRC error, unrecognized by OpenCPN/SignalK
Thomas (rooco) assumes a hardware failure ...

Michael
Find
Reply


Messages In This Thread
Air pressure with Moitessier HAT - by Luckbert - 2021-01-15, 12:15 PM
RE: Air pressure with Moitessier HAT - by Sailoog - 2021-01-17, 07:12 PM
RE: Air pressure with Moitessier HAT - by Sailoog - 2021-01-17, 08:19 PM
RE: Air pressure with Moitessier HAT - by Geronius - 2021-02-07, 01:16 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)