Hi,
I am testing Openplotter on a Pi 4 using SignalK test data. When I select a point in Opencpn to navigate to and activate the route, I can see the route details on the "This Leg" window in OpenCpn such as Bearing TTG, VMG and XTE. However when I look at the SignalK data these parameters do not appear. Do I need to set up some connection between SignalK and Opencpn so that opencpn sends the route data to SignalK? It seems as if SignalK only sees the test data - there is no other input stream.
Jodel
I am testing Openplotter on a Pi 4 using SignalK test data. When I select a point in Opencpn to navigate to and activate the route, I can see the route details on the "This Leg" window in OpenCpn such as Bearing TTG, VMG and XTE. However when I look at the SignalK data these parameters do not appear. Do I need to set up some connection between SignalK and Opencpn so that opencpn sends the route data to SignalK? It seems as if SignalK only sees the test data - there is no other input stream.
Jodel