(2021-02-10, 02:53 PM)Jodel Wrote: I am confused!. The only input I have to opencpn is the default one from signalk on port 3000 using signalk protocol.
This is the input I would like to debug and filter.
The only output I have from opencpn is the route data to signal k on 10110.
ah, I use nmea going into opencpn, much easier to filter and some plugins don't see the signalk data but need nmea. Give it a try, disable the signalk input and try tcp on port 10110 with ignore sentences apd & rmd. Works fine and the 2 sentences are available as signalk for anything else which might want to see them.