This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Reading data from Tinypilot Uart
#1
I am not able to see any readable data from the Uart on the Tinypilot. I have run through all the normal baud rates but only see strings of unreadable characters. i was hoping to see the data in readable form so I can parse the strings and use the values to enable my digital input to my hydraulic steering ( it uses 2 data lines either high or low to control the hydraulic cylinder) Currently I use a joystick to control the cylinder. Any information on this would be greatly appreciated.
Reply


Messages In This Thread
Reading data from Tinypilot Uart - by Dusty_Dave - 2021-02-19, 10:12 PM
RE: Reading data from Tinypilot Uart - by ironman - 2021-02-20, 08:56 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)