This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
OpenMarine › OpenPlotter › Documentation v
Tinypilot Hat

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Tinypilot Hat
SVHM Offline
Member
***
Posts: 67
Threads: 14
Joined: Jun 2020
Reputation: 1
#1
2021-03-07, 04:17 AM
I purchased a Tinypilot Hat last year and have finally gotten round to trying to install it.   I am having trouble installing the hat because it doesn't seem to have a marking for pin 1 that corresponds with the GPIO pin 1.  I connected it the way I thought it would go but when I power it up, only the display back light comes on but nothing comes on screen.  It then doesn't get recognized by Pypilot in Openplotter.  I am connecting it to my own Rasberry Pi that also has a dAISy AIS card installed.  Further, I had already installed an IMU before purchasing the hat and it is connected via I2C and seems to read ok in Pypilot. 

Could someone help with the proper install?

Thanks
Find
Reply


Messages In This Thread
Tinypilot Hat - by SVHM - 2021-03-07, 04:17 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)