mairas,
I'm still playing around and learning here...
does SensEsp contain a capacitive library? Thinking to set up the SH-Esp to a water bottle and test capacity with some foil and see if I can make it work. Then, I can go step up to installing a sensor onto my holding tank. I can install one of my boxes near by and send the data to SignalK over wifi.
Thanks
Steve
Another question:
In one of the NMEA gateways I built, I ran into a compatibility issue. Exhibition requires Actisense to run at 250,000 baud and their instructions say that ISO versions (at 115,200 baud) need to be upgraded. Is this something that can be adjusted in software somewhere? If not, then that box may become the box for previous post...
Steve
I'm still playing around and learning here...
does SensEsp contain a capacitive library? Thinking to set up the SH-Esp to a water bottle and test capacity with some foil and see if I can make it work. Then, I can go step up to installing a sensor onto my holding tank. I can install one of my boxes near by and send the data to SignalK over wifi.
Thanks
Steve
Another question:
In one of the NMEA gateways I built, I ran into a compatibility issue. Exhibition requires Actisense to run at 250,000 baud and their instructions say that ISO versions (at 115,200 baud) need to be upgraded. Is this something that can be adjusted in software somewhere? If not, then that box may become the box for previous post...
Steve