2021-04-18, 03:37 PM
Hi all
Thanks so much for the responses!
Sorry, but I didnt really understand - just a newbie here. The I2C stuff with the was my first attempt at making anything!
according to what I could see, the LIS3MDL(on the berry site here: https://ozzmaker.com/berryimu-quick-start-guide/#i2c , the magnenometer should have worked on 0x1C,,,,
The berry has 3 sensors - all 3 (imu/magnemometer/barometic & temperature) had addresses reported back to the I2C program - but I could only seem to get temperature reporting into Signal K - and just the autodiscover prompt on Pypilot (when I tried to configure).... When I ran through the example code for the compass, it worked - or at least seemed to (the sample came out with 3 rows of figures when changed with orientation).
Is that chip supported directly in Pypilot - for magnetic compass or is there a preferred one I could get my hands on instead?
Thanks so much for the responses!
Sorry, but I didnt really understand - just a newbie here. The I2C stuff with the was my first attempt at making anything!
according to what I could see, the LIS3MDL(on the berry site here: https://ozzmaker.com/berryimu-quick-start-guide/#i2c , the magnenometer should have worked on 0x1C,,,,
The berry has 3 sensors - all 3 (imu/magnemometer/barometic & temperature) had addresses reported back to the I2C program - but I could only seem to get temperature reporting into Signal K - and just the autodiscover prompt on Pypilot (when I tried to configure).... When I ran through the example code for the compass, it worked - or at least seemed to (the sample came out with 3 rows of figures when changed with orientation).
Is that chip supported directly in Pypilot - for magnetic compass or is there a preferred one I could get my hands on instead?