2021-04-21, 06:50 PM
I went into many difficulties trying to configure signal K to :
In fact I gave up, and following a co-forumer suggestion, I had to connect an extra RS232 GPS to the VHF !
All this should be treated with an AUTO mode, like in "Add to Signal K " or "Add to GPSD" buttons from the Serial Application ...
Off course all the miscellaneous actions to avoid loops should be automatic and behind the curtain !
Point 1 and 3 could maybe use the same button ?
In the actual state, OP is almost not usable ...
- Add output to an rs232 VHF (GLL should suffice, 4800 Bd ) ;
- add input from rs232 AIS receiver (e.g. AIVDM, 38400Bd) ;
- Add Output towards a Pilot (RS232, 4800 Bd) ;
In fact I gave up, and following a co-forumer suggestion, I had to connect an extra RS232 GPS to the VHF !
All this should be treated with an AUTO mode, like in "Add to Signal K " or "Add to GPSD" buttons from the Serial Application ...
Off course all the miscellaneous actions to avoid loops should be automatic and behind the curtain !
Point 1 and 3 could maybe use the same button ?
In the actual state, OP is almost not usable ...
Cordialement
Didier B
Pi4, SSD USB3, OP 3.0 Touch SK 3.2.1 OpenCPN 5.8.4 : Thank you Thank you Thank you
Didier B
Pi4, SSD USB3, OP 3.0 Touch SK 3.2.1 OpenCPN 5.8.4 : Thank you Thank you Thank you