2021-04-21, 07:33 PM
(2021-04-21, 06:50 PM)Didier B Wrote: I went into many difficulties trying to configure signal K to :
The difficulties were not related to 'RS232' aspects, but to the signal K configuration !
- Add output to an rs232 VHF (GLL should suffice, 4800 Bd ) ;
- add input from rs232 AIS receiver (e.g. AIVDM, 38400Bd) ;
- Add Output towards a Pilot (RS232, 4800 Bd) ;
In fact I gave up,and following a co-forumer suggestion, I had to connect an extra RS232 GPS to the VHF !
All this should be treated with an AUTO mode, like in "Add to Signal K " or "Add to GPSD" buttons from the Serial Application ...
Off course all the miscellaneous actions to avoid loops should be automatic and behind the curtain !
Point 1 and 3 could maybe use the same button ?
In the actual state, OP is almost not usable ...
It took me a while to grasp the concepts, also. But once I figured it out, it works just fine. For what it's worth, here's my experience with my VHF:
I connected a usb serial cable to the RX/TX of the radio and plugged it into my RPi. As you stated, I added the connection into the Serial app as NMEA0184 and added it to SK.
In SK, I check the settings and put "VHFLocation" in "Output Events" field. This will be used to open the port to send data TO the VHF. Since my serial connection is bidirectional, I put "VHFAlert" into the "Sentence Event" to RECEIVE any DSC and DSE sentences sent from the radio. That's just the port set up.
Then, and this is the confusing part that I had to mess with to figure out, I had to install and set up the "NMEA0183-to-NMEA0183" plug in to essentially route the NMEA0183 data. In the plugin settings, I created the first filter with the input event of "nmea0183out", set the output event to "VHFLocation", and turned on GGA, GLL, GNS, and RMC, as these are the four NMEA0183 sentences my radio can receive. What this seems to do is every time there is a data even on the NMEA0183out (the main 0183 data stream of SK) it sends GGA, GLL, GNS, and RMC to VHFLocation, which we have routed to the output of the VHF serial connection. On my set, this works beautifully.
Next, I added another input event in the NMEA-to-NMEA plugin that "watches" for a "VHFAlert" event from port and outputs that event to nmea0183out. My radio only sends DSC and DSE sentences, and if it does send them, the plugin dumps them into the SK NMEA0183 data stream. This I'm unsure whether it works or not, as I haven't received any DSC alerts to know whether OpenCPN will pick those up or not, but it should work just fine. Anyone have any feedback on this?
For yours, you'll need an additional port for the AIS side of things, for sure, as the baud rate is different. But the idea is basically the same. You'll set up and receive data on that port. Then, you'll need a channel for it and insert it into the NMEA0183 data stream.
I myself would like have a better understanding of how NMEA data works within SK and what the difference is between nmea0183 and nmea0183out, as the "out" has a lot more data and information in it than nmea0183. Both of those seems to be reserved for SK and ancillary ports (such as VHFAlert or autopilot) must get their data from that stream of information.
Steve