2021-05-03, 07:47 PM
I have a different IMU than you but at one point, I did try the one you are using and I configured it a little different:
1. VCC - check your literature - on the one I had, you either had to give it 5v or short circuit the two pads that are next to the voltage regulator
2. I did not connect EDA and ECL - just SCL and SDA
on the Pypilot screen you should see "Detected IMU: MPU9225".
I don't think the "I2C enabled | Not running" is a good thing
1. VCC - check your literature - on the one I had, you either had to give it 5v or short circuit the two pads that are next to the voltage regulator
2. I did not connect EDA and ECL - just SCL and SDA
on the Pypilot screen you should see "Detected IMU: MPU9225".
I don't think the "I2C enabled | Not running" is a good thing