2021-05-08, 02:50 AM
you will want to operate in hbridge mode then, and use d9 and d10 for pwm outputs for each direction. If you ground D6, hbridge mode is used
Question on using an SPX Tiller Drive using a Simple H Bridge /PyPilot
|
« Next Oldest | Next Newest »
|
Messages In This Thread |
Question on using an SPX Tiller Drive using a Simple H Bridge /PyPilot - by Redline - 2021-05-07, 06:53 AM
RE: Question on using an SPX Tiller Drive using a Simple H Bridge /PyPilot - by seandepagnier - 2021-05-08, 02:50 AM
RE: Question on using an SPX Tiller Drive using a Simple H Bridge /PyPilot - by Redline - 2021-05-09, 05:13 AM
RE: Question on using an SPX Tiller Drive using a Simple H Bridge /PyPilot - by seandepagnier - 2021-05-09, 05:31 PM
|