BME 280 to Signal K

[Netdrum]

Are you certain that you have a BME280 and not a BMP280? The zero figure for humidity when executing the python script earlier suggests that it might not have that capability.

I have a BMP and could recreate your problem exactly if I add the device as a BME (although this has worked for me in earlier versions of OP). Everything seemed to be configured but no data in SK.

I deleted the sensor in Openplotter>I2C and added it as a BMP280 on the same address 0x77, added the label environment.inside.temperature against the temperature line in the sensor display, added the connection and I see valid data in SK right away.

I have to say your readings from the python script still look awry. Here's mine:
Chip ID     : 88
Version     : 1
Temperature :  25.09 C
Pressure :  994.641682705 hPa
Humidity :  0.0 %

No humidity as it's a BMP280.

Good luck
Oh and you don't need the BME280 plugin in so it can be deleted.

Ok bit embarrassed about this, but your absolutely correct my sensor is a BMP 280 and not a BME, I bought it from Amazon last July and it’s been sitting there waiting until I had some to to play and set it up. So just rechecked my Amazon and it’s a BMP. Just as soon as I get a chance I will reconfigure and test and report back .

Thank you for taking the time to help me with this and replying to my post. 

I will let you know how it works will be interesting to see how the temp readings are then.

Best Regards 
D