This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
OpenMarine › OpenPlotter › How do I...? v
IMU placement

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
IMU placement
jhoop Offline
Junior Member
**
Posts: 8
Threads: 3
Joined: Jan 2021
Reputation: 0
#1
2021-07-12, 01:24 PM
Hello everyone
I'm wondering how and where you all put you IMU's?
I would like it as close to centerline and center of gravity but I know that it can't handle the long wire run.
Do you use an ESP8266 or ESP32 to get the data to the Pi? But then I read that there is a lag in the data.
How to you compensate for where it is usually located, close to the Pi? Or it doesn't matter in the real world.
Thanks
Jim
Find
Reply


Messages In This Thread
IMU placement - by jhoop - 2021-07-12, 01:24 PM
RE: IMU placement - by baltika_no_9 - 2021-07-13, 09:35 AM
RE: IMU placement - by seandepagnier - 2021-07-13, 05:11 PM
RE: IMU placement - by yiannis - 2023-04-06, 11:42 AM
RE: IMU placement - by PaddyB - 2023-04-08, 08:55 AM
RE: IMU placement - by mgrouch - 2023-04-06, 01:51 PM
RE: IMU placement - by Techstyle - 2023-04-07, 05:52 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)