BME280 > SignalK no data/gauges

[Jay_cd33]

hi jay,

THANKS THANK THANKS!!!!

Ic2 was/is enable as well as 1-wire.

Good news, the new sensor (bmp280) is working fine. No issues at all, see foto's. I don't have humidity but thats for me not important (would be nice, not have to have).

In totaly the project is looking like this:

Raspberry pi 4 8 gb (second hand because new it's not availble)
Pican-M
OPENPLOTTER!!
1-wire with 2 sensors for temp outside and reserve
ic2 with bmp280 and gy91 [inside, pressure and roll, till, compass (bme280 on the GY-91 thats all the story above about)]
Screen AOC 16T2 16 inch touchscreen (be aware the screen needs about 2,5 amp on 5 volts and the raspberry gives only 0,9 amps so you needs 3 wires, 1 power (different 2,5 amp usb socket) 1 touchscreen wire (usb3.0) to raspberry and 1 Micro HDMI to Micro-HDMI and that i could not find. I build in the raspberry behind a cupboard and have now 3 sockets for the screen, 1 HDMI, and 2 USB 3.0.
1 RTL-SDR dongle with mini whip for NAVTEX and weatherfax and SSB-receiver


Arduino to the nmea 2000 with sensors for fueltank watertank rpm etc not finished totaly

See some pictures, its not finished yet but you get a impression.

@ Jay Thanks a lot again.

Renze

Renze,

Glad it is working.  Pictures look great. 
Jay