2021-07-20, 12:58 PM
I have bought Sean's pilot, complete to incorporate it into my princess 36, the motor controller is 2.1, I have seen that the hydraulic pump has a consumption of 12 amps on its label, I believe that in large rudder efforts, it exceeds this consumption.
Is this driver that I bought valid?
Can I replace it with another unit?
If I implant a relay and diode system on its output, do you think it would work?
I have not yet mounted anything until I have the installation sure.
I await your responses.
Greetings
Is this driver that I bought valid?
Can I replace it with another unit?
If I implant a relay and diode system on its output, do you think it would work?
I have not yet mounted anything until I have the installation sure.
I await your responses.
Greetings