2021-09-13, 08:51 PM
Hi everyone
I am setting up open plotter v.2 in my Rpi 3+.All was fine with open CPN and Pypilot .But when I went for AIS following " reads the docs" fails.
I want to receive data with a RTL2832u usb device.
I calibrate it rigorously and obtain 52 ppm.I get a antenna calibrated to 162 Mhz and proved it in laptop with window 7, using Open CPN plugin and rtl_ais program, and works fine.
But when I go back to the Rpi and follow the steps, the conection in signal K exits(UDP:10110),the conection in Open CPN exits(SignalK:3000) ,in SDR VHF process AIS is in green, active , running, but I can´t see anything in Open CPN.
I can´t found where the mistake is , can you help me?
Thanks in advance
Gustavo
I am setting up open plotter v.2 in my Rpi 3+.All was fine with open CPN and Pypilot .But when I went for AIS following " reads the docs" fails.
I want to receive data with a RTL2832u usb device.
I calibrate it rigorously and obtain 52 ppm.I get a antenna calibrated to 162 Mhz and proved it in laptop with window 7, using Open CPN plugin and rtl_ais program, and works fine.
But when I go back to the Rpi and follow the steps, the conection in signal K exits(UDP:10110),the conection in Open CPN exits(SignalK:3000) ,in SDR VHF process AIS is in green, active , running, but I can´t see anything in Open CPN.
I can´t found where the mistake is , can you help me?
Thanks in advance
Gustavo