2021-10-04, 01:48 PM
OK Update, as follows
I edited my config.txt file to include
dtoverlay=uart5,txd1_pin=08,rxd1_pin=10
re-ran
sudo cat /dev/ttyAMA0
Got illegible GPS data.
Edited the serial device connection to signal K and set the baud to 9600.
Still no throughput to signal K.
hard Set the serial Baud rate to 9600 in terminal using
stty -F /dev/serial0 raw 9600 cs8 clocal -cstopb
reboot
and...boom!
Problem solved. working like a charm. (5 total signal k throughput deltas/second and 15 signal k paths)
[url=https://www.raspberrypi.org/documentation/computers/configuration.html#primary-uart][/url]
I edited my config.txt file to include
dtoverlay=uart5,txd1_pin=08,rxd1_pin=10
re-ran
sudo cat /dev/ttyAMA0
Got illegible GPS data.
Edited the serial device connection to signal K and set the baud to 9600.
Still no throughput to signal K.
hard Set the serial Baud rate to 9600 in terminal using
stty -F /dev/serial0 raw 9600 cs8 clocal -cstopb
reboot
and...boom!
Problem solved. working like a charm. (5 total signal k throughput deltas/second and 15 signal k paths)
[url=https://www.raspberrypi.org/documentation/computers/configuration.html#primary-uart][/url]