Hi, the opencpn errors you can ignore, just means opencpn isn't running.
The supress nmea events is usually best left off, when off any nmea0183 coming in automatically gets sent out again to tcp port 10110.
So are you seeing no signalk sentences in the data browser tab on the signalk server? Any nmea data which can be converted to signalk (which is lots) should show up there
Some screen shots would be handy, if no data coming in from instruments it could be wrong serial port or baud rate wrong...
and from your other thread - sorry no answer to that one, usually this forum is very good but that thread seems to have been overlooked..
The raspberry Pi should do the job of the multiplexer, though you can end up needing a few serial/usb adaptors.
The supress nmea events is usually best left off, when off any nmea0183 coming in automatically gets sent out again to tcp port 10110.
So are you seeing no signalk sentences in the data browser tab on the signalk server? Any nmea data which can be converted to signalk (which is lots) should show up there
Some screen shots would be handy, if no data coming in from instruments it could be wrong serial port or baud rate wrong...
and from your other thread - sorry no answer to that one, usually this forum is very good but that thread seems to have been overlooked..
The raspberry Pi should do the job of the multiplexer, though you can end up needing a few serial/usb adaptors.