2021-10-26, 10:09 PM
Good day,
I have successfuly connected a multiplexer (Yakmux) to my Rpi4 running Openplotter/Signal K. I now receive data from my nmea0183 instruments and my GPS antenna (both wired to the multiplexer).
I now want to output nmea data in 2 ways:
1. Send GPS sentences to my VHF radio
2. Send relevant sentences to my autopilot (back up through the multiplexer and into the nmea network)
I've researched this, followed many of the threads here and given it a go. The GPS to VHF issue was an easier place to start, so that's where I've spent my time. Alas it's not working.
Instead of posting a lot of screenshots, what information do you folks need to help me? I essentially created a connection in Openplotter, then added to Signal K. I downloaded nmea0183-nmea0183 app...followed the recipe...nope...
I took screenshots of everything, please advise...thank you very much.
I have successfuly connected a multiplexer (Yakmux) to my Rpi4 running Openplotter/Signal K. I now receive data from my nmea0183 instruments and my GPS antenna (both wired to the multiplexer).
I now want to output nmea data in 2 ways:
1. Send GPS sentences to my VHF radio
2. Send relevant sentences to my autopilot (back up through the multiplexer and into the nmea network)
I've researched this, followed many of the threads here and given it a go. The GPS to VHF issue was an easier place to start, so that's where I've spent my time. Alas it's not working.
Instead of posting a lot of screenshots, what information do you folks need to help me? I essentially created a connection in Openplotter, then added to Signal K. I downloaded nmea0183-nmea0183 app...followed the recipe...nope...
I took screenshots of everything, please advise...thank you very much.