This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
i2c BMP sensor
#3
Ok, I solved it. 

So for others that may have the same issue:

Apart from the above hack in the file you need to do this:

The BMx280 sensor can work on address 76 or 77. Apparently, even though the i2C module from Openplotter sees the 76 address, the library assumes the address to be 77...

To get the sensor to work on 77 you need to connect the SDO pin to 3.3V. After I did that, removed the sensor and reinstalled at 77 everything worked.

BW,
 Bas
Reply


Messages In This Thread
i2c BMP sensor - by bvandijk - 2021-12-20, 07:52 AM
RE: i2c BMP sensor - by bvandijk - 2021-12-20, 12:47 PM
RE: i2c BMP sensor - by bvandijk - 2021-12-21, 09:26 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)