This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
OpenMarine › OpenPlotter › How do I...? v
Connect inverter with RS-232 to raspberry PI4

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Connect inverter with RS-232 to raspberry PI4
nuvolare Offline
Junior Member
**
Posts: 3
Threads: 1
Joined: Feb 2022
Reputation: 0
#6
2022-02-11, 07:46 PM
ok, so i've removed the connection by usb cable, and it was red, after that i puted again and it was green after refresh. I've deleted the serial from the application string, i'had to set up the device from openplotter/serial and "Add to signal K", but notting is changed, on Dashboard, there is no signal on right up corrner of the signal K. I don't know what i've to do
Find
Reply


Messages In This Thread
RE: Connect inverter with RS-232 to raspberry PI4 - by nuvolare - 2022-02-11, 07:46 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)