2022-08-01, 04:54 AM
(2022-07-30, 10:58 PM)Boatingbaileys Wrote: Will do, and will respond to the above. Currently got limited access to internet but will be back i a couple of days.
Thanks, actually I got it working, I had to add some code to get the I2C interface to work. I had to define the pins
Code:
Wire.begin(22,21)
where 22 is the SCL pin and 21 is the SDA pin.
I think you may have got around this by better defining the board you were using, but I had trouble with that in version 2.