This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
OpenMarine › OpenPlotter › General discussion v
Pican-M not working after upgrade.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Pican-M not working after upgrade.
artemis Offline
Junior Member
**
Posts: 1
Threads: 0
Joined: Aug 2023
Reputation: 0
#2
2023-08-15, 06:38 AM
Did you ever figure this out? I'm having the same issue. The serial port works fine with Openplotter 2, but a fresh install of Openplotter 3 results in a non-working /dev/ttyS0.
Find
Reply


Messages In This Thread
Pican-M not working after upgrade. - by zzzdgr - 2022-03-31, 03:16 PM
RE: Pican-M not working after upgrade. - by artemis - 2023-08-15, 06:38 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)