This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Basic IMU/I2C setup question
#4
(2017-04-05, 07:52 PM)jswalwell Wrote: Hmm, was not aware of node-red.  I can see how that could work, I'll take a look at it.  But really, isn't openplotter setup to forward I2C sensor data to opencpn or other?  Does it do it automatically and I'm just not aware of it?

Is the MPU-9250 data showing up as signalk ?   If so then in openplotter beta (not sure about v0.8) you can create nmea083, in the openplotter window look for "NMEA 0183 generator" in the tools menu. I use it to convert a signalk ds18 engine temperature sensor into a water temperature nmea 0183 sentence so it can be seen in opencpn dashboard. 
Reply


Messages In This Thread
Basic IMU/I2C setup question - by jswalwell - 2017-04-05, 06:49 PM
RE: Basic IMU/I2C setup question - by dreuf - 2017-04-05, 07:44 PM
RE: Basic IMU/I2C setup question - by jswalwell - 2017-04-05, 07:52 PM
RE: Basic IMU/I2C setup question - by PaddyB - 2017-04-06, 10:41 AM
RE: Basic IMU/I2C setup question - by jswalwell - 2017-04-06, 02:14 PM
RE: Basic IMU/I2C setup question - by jswalwell - 2017-04-06, 07:09 PM
RE: Basic IMU/I2C setup question - by abarrow - 2017-04-07, 08:01 PM
RE: Basic IMU/I2C setup question - by jswalwell - 2017-04-07, 08:20 PM
RE: Basic IMU/I2C setup question - by abarrow - 2017-04-07, 08:50 PM
RE: Basic IMU/I2C setup question - by abarrow - 2017-04-08, 04:41 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)