2022-06-28, 03:02 PM
Hi all
Can someone advise what is the best/optimum connections (in an OpenPlotter/SignalK configuration)
Ive been having some performance/crashing issues lately and I'm concerned that my configuration has suffered from too much tinkering under the hood.
FWIW here are my current settings:
OpenCPN Ver 5.6.2
Connections
Network, Output, protocol=UDP, Address=localhost, port 10119, priority=1
Network, Intput, protocol=Signal K, Address=localhost, port=3000, priority=1
SignalK ver 1.43
Connections
gps - NMEA0183, serial, 4800, o/p event "" ,i/p event "gps"
ais - NMEA0183, serial,38400, o/p event "" ,i/p event "ais"
seatalk - NMEA0183,4800, o/p event "" ,i/p event "seatalk"
openCPNOut - NMEA0183, UDP, port 10119,i/p event "autopilot"
Active SK Plugins
Forward and Filter NMEA
Node Red
Set System Time
Derived Data for True Wind
OpenPlotter Ver 2 on RPi Model 3b (16GB)
Thanks
Steve
Can someone advise what is the best/optimum connections (in an OpenPlotter/SignalK configuration)
Ive been having some performance/crashing issues lately and I'm concerned that my configuration has suffered from too much tinkering under the hood.
FWIW here are my current settings:
OpenCPN Ver 5.6.2
Connections
Network, Output, protocol=UDP, Address=localhost, port 10119, priority=1
Network, Intput, protocol=Signal K, Address=localhost, port=3000, priority=1
SignalK ver 1.43
Connections
gps - NMEA0183, serial, 4800, o/p event "" ,i/p event "gps"
ais - NMEA0183, serial,38400, o/p event "" ,i/p event "ais"
seatalk - NMEA0183,4800, o/p event "" ,i/p event "seatalk"
openCPNOut - NMEA0183, UDP, port 10119,i/p event "autopilot"
Active SK Plugins
Forward and Filter NMEA
Node Red
Set System Time
Derived Data for True Wind
OpenPlotter Ver 2 on RPi Model 3b (16GB)
Thanks
Steve