(2022-06-28, 03:02 PM)affinite Wrote: Hi allIt looks like you are creating new events for each piece of data. Wouldn't you then need to forward and filter those into the nmea stream to get that info into OpenCPN? I may be way off here, but I recall that info needing to be in the correct place. You may want to try just changing the i/p event and dumping everything into nmeaOutput, then use OCPN TCP/IP connection on port 10110 and see if that works.
Can someone advise what is the best/optimum connections (in an OpenPlotter/SignalK configuration)
Ive been having some performance/crashing issues lately and I'm concerned that my configuration has suffered from too much tinkering under the hood.
FWIW here are my current settings:
OpenCPN Ver 5.6.2
Connections
Network, Output, protocol=UDP, Address=localhost, port 10119, priority=1
Network, Intput, protocol=Signal K, Address=localhost, port=3000, priority=1
SignalK ver 1.43
Connections
gps - NMEA0183, serial, 4800, o/p event "" ,i/p event "gps"
ais - NMEA0183, serial,38400, o/p event "" ,i/p event "ais"
seatalk - NMEA0183,4800, o/p event "" ,i/p event "seatalk"
openCPNOut - NMEA0183, UDP, port 10119,i/p event "autopilot"
Active SK Plugins
Forward and Filter NMEA
Node Red
Set System Time
Derived Data for True Wind
OpenPlotter Ver 2 on RPi Model 3b (16GB)
Thanks
Steve
Just looked and that is nmea0183Out to get the data into 10110 and send to OCPN.